SKF self-aligning ball bearing, nylon cage, 2203 ETN9

The inner ring has two rows of raceways, and the outer ring raceway is spherical, with the center of curvature of the sphere coinciding with the bearing center. Therefore, the inner ring, balls, and cage can tilt freely relative to the outer ring. This allows for automatic adjustment of axial deviations caused by machining or installation errors of the shaft and bearing housing.

Tapered bore bearings can be installed with adapter sleeves.

Structure, Form, and Features

The outer ring raceway is spherical, with its center of curvature coinciding with the bearing center. Therefore, the inner ring, balls, and cage can rotate freely around the bearing center, providing self-aligning capability. Suitable for applications such as drive shafts where centering the shaft and housing is difficult or where the shaft is prone to warping.

Allowable self-aligning angle

The allowable self-aligning angle of a self-aligning ball bearing, under normal load conditions, is approximately 0.07~0.12 radians (4°~7°). Depending on the mounting dimensions around the bearing, there may be special cases where this self-aligning angle cannot be achieved; please pay attention to this.

• Accommodation of static and dynamic misalignment
  Like spherical roller bearings or CARB bearings, this type of bearing also has self-aligning capability.
  

• Excellent High-Speed ​​Performance
  Compared to any other type of rolling bearing, self-aligning ball bearings generate the lowest friction and have the lowest temperature rise even at high speeds.

• Minimum Maintenance Requirements
  Because the bearing generates less heat, its temperature is lower, thus extending its service life and maintenance intervals.
  

• Low Friction
  The clearance fit between the rolling elements and the outer ring reduces friction and frictional heat.

• Excellent Light Load Performance
  Self-aligning ball bearings have lower minimum load requirements.

• Low Noise
  For example, self-aligning ball bearings can reduce the noise and vibration levels of fans.

1

Self-aligning Ball Bearing

2

Self-aligning Ball Bearing

2

Diameter series 2

3

Diameter series 3

...

...

E

Optimized internal design for improved load-bearing capacity

K

Inner ring inner diameter tapered hole, reference taper 1:12

C1

Clearance conforms to group 1 of the standard, less than clearance C2

C2

Clearance conforms to group 2 of the standard, less than clearance C0

C0

Clearance conforms to group 0 of the standard, omitted in the code, not indicated.

C3

Clearance conforms to the standard's 3 groups, greater than C0 clearance

C4

Clearance conforms to the standard's 4 groups, greater than C3 clearance

C5

Clearance conforms to the standard's 5 groups, greater than C4 clearance

Rolling bearings are precision components and should be used with great care. Even high-quality bearings will not achieve the desired effect if used improperly. The following are precautions for bearing use:

(1) Keep the bearing and its surrounding environment clean: Even tiny dust particles invisible to the naked eye can have adverse effects on the bearing.

Therefore, keep the surrounding area clean to prevent dust from entering the bearing;

(2) Use with care: Strong impacts on the bearing during use can cause scratches or indentations, leading to accidents. In severe cases, it can cause cracks or breakage, so caution must be taken;

(3) Use bearing-specific tools: Special tools must be used and cannot be arbitrarily substituted;

(4) Prevent bearing rust: Hand sweat can cause rust when operating bearings, so be sure to use clean hands, wear gloves, and be aware of corrosive gases.